oru.sePublications
Change search
Link to record
Permanent link

Direct link
BETA
Karlsson, Patrik
Publications (2 of 2) Show all publications
Karlsson, P., Jarl, M. & Enghag, P. (2005). Use of roller straightener to produce wire cast. Hutnik, 72(2), 69-71
Open this publication in new window or tab >>Use of roller straightener to produce wire cast
2005 (English)In: Hutnik, ISSN 0018-8077, Vol. 72, no 2, p. 69-71Article in journal (Refereed) Published
Abstract [en]

A three roller and a two roller straightener were used to produce the wire cast. The three roller straightener was not appropriate, but with the two roller straightener it was possible to produce the required wire cast. Cast was measured before and after the wire entered the capstan. Results of different straightener setting are reported. Micro hardness measurements in the cross sections of the wires revealed no problems with this method.

National Category
Engineering and Technology
Research subject
Mechanical Engineering
Identifiers
urn:nbn:se:oru:diva-4494 (URN)
Available from: 2007-07-12 Created: 2007-07-12 Last updated: 2017-10-18Bibliographically approved
Karlsson, P. & Jarl, M. (2005). Wire cast obtained by use of roll straightening as an alternative to turning of the die box. Stockholm: Jernkontoret
Open this publication in new window or tab >>Wire cast obtained by use of roll straightening as an alternative to turning of the die box
2005 (English)Report (Other academic)
Place, publisher, year, edition, pages
Stockholm: Jernkontoret, 2005
Series
Jernkontorets forskning ; TO 33-14
National Category
Mechanical Engineering
Research subject
Mechanical Engineering
Identifiers
urn:nbn:se:oru:diva-4478 (URN)
Available from: 2008-03-25 Created: 2008-03-25 Last updated: 2017-10-18Bibliographically approved
Organisations

Search in DiVA

Show all publications