To Örebro University

The problem addressed in this thesis is discrimination of gases with an array of partially selective gas sensors. Metal oxide gas sensors are the most common gas sensing technology since they have, compared to other gas sensing technologies, a high sensitivity to the target compounds, a fast response time,they show a good stability of the response over time and they are commercially available. One of the most severe limitation of metal oxide gas sensors is the scarce selectivity, that means that they do not respond only to the compound for which they are optimized but also to other compounds. One way to enhance the selectivity of metal oxide gas sensors is to build an array of sensorswith different, and partially overlapping, selectivities and then analyze the response of the array with a pattern recognition algorithm. The concept of anarray of partially selective gas sensors used together with a pattern recognition algorithm is known as an electronic nose (e-nose).In this thesis the attention is focused on e-nose applications related mobile robotics. A mobile robot equipped with an e-nose can address tasks like environmental monitoring, search and rescue operations or exploration of hazardous areas. In e-noses mounted on mobile robots the sensing array is most often directly exposed to the environment without the use of a sensing chamber.This choice is often made because of constraints in weight, costs and because the dynamic response obtained by the direct interaction of the sensors with the gas plume contains valuable information. However, this setup introduces additional challenges due to the gas dispersion that characterize natural environments.Turbulent and chaotic gas dispersal causes the array of sensors to be exposed to rapid changes in concentration that cause the sensor response to behighly dynamic and to seldom reach a steady state. Therefore the discriminationof gases has to be performed on features extracted from the dynamics of the signal. The problem is further complicated by variations in temperature and humidity, physical variables to which metal oxide gas sensors are crossensitive.For these reasons the problem of discrimination of gases when an array of sensors is directly exposed to the environment is different from when the array of sensors is in a controlled chamber.

This thesis is a compilation of papers whose contributions are two folded.On one side new algorithms for discrimination of gases with an array of sensors directly exposed to the environment are presented. On the other side, innovative experimental setups are proposed. These experimental setups enable the collection of high quality data that allow a better insight in the problem of discrimination of gases with mobile robots equipped with an e-nose. The algorithmic contributions start with the design and validation of a gas discrimination algorithm for gas sensors array directly exposed to the environment. The algorithmis then further developed in order to be able to run online on a robot, thereby enabling the possibility of creating an olfactory driven path-planning strategy. Additional contributions aim at maximizing the generalization capabilitiesof the gas discrimination algorithm with respect to variations in the environmental conditions. First an approach in which the odor discrimination is performed by an ensemble of linear classifiers is considered. Then a feature selection method that aims at finding a feature set that is insensitive to variations in environmental conditions is designed. Finally, a further contribution in this thesis is the design of a pattern recognition algorithm for identification of bacteria from blood vials. In this case the array of gas sensors was deployed ina controlled sensing chamber.