Detta examensarbete behandlar frågan om det anses möjligt att konstruera ett hisshus till en skidlift som är mindre än de som finns idag. Konstruktionen har hårda krav att uppfylla varpå det viktigaste ar att hisshuset endast får vara 42 mm brett. Detta krav är ett av åtta som satts upp av Axet Teknikutveckling AB. Inget känt hisshus som möter dessa krav finns idag på marknaden och därför finns ett intresse i denna konstruktion. Meningen med att möta dessa krav är att en eventuell nyutveckling av den befintliga konstruktionen skulle kunna vara aktuellt att användas i en speciell typ av skidlift. Denna typ av skidlift kallas "Teleskop-lift".
Det har tagits fram ett konstruktionsförslag utifrån den befintliga konstruktionen som Axet Teknikutveckling AB har idag. Däremot har dess mekaniska funktion och utformning modifierats avsevärt. Funktion och utformning redogörs för samtliga komponenter och avslutas med en fullständig funktionsbeskrivning. Lämpligt fortsatt arbete, utifrån de underlag som tagits fram i denna rapport, skulle vara att skapa en enklare prototyp. Detta krävs for att utföra tester så att en optimal bromsverkan för konstruktionen kan tas fram.
The following thesis treats the question if it possible to design a rope retractor which meets the given requirements that is set. The design has to meet strict requirements and the most important one ofthem is that it cannot be wider than 42 millimeters. This is just one of eight requirements which have been set by the company Axet Teknikutveckling AB. There is no known rope retractor on the market today that meets these requirements therefore there is a big interest in this design. The purpose is to meet these requirements with a possible design so that it would be useful in a special type of ski lift called "Teleskop-lift".
The design is based on a current rope retractor that Axet Teknikutveckling AB produces today. Although the new construction has been modified significantly both in mechanical function and design. The report describes and illustrates all of the components individually and sums up with a total function declaration. The recommended next steps would be to produce a simple prototype. This prototype should be used for testing which then would make it possible to optimize the break capacity for the rope retractor.